Dear All,I am using ACS 5.0 version. Devices cannot able to access ACS If I am creating /32 IP device(AAA Client) address in the ACS.When I define subnet for the device e.g. /24 then all devices in the same subnet will start working.Why single IP add...
Hello,I am new to wireless and would like to know what are the best practices for placing an AP with omni-directional antenna. I have a 1500 series mesh AP.Can any one point out to some good documentation regarding the coverage of these antenna and b...
Hello,I have a 1500 series wireless mesh AP connected to a 2006 WLC. I mistakenly initialized the AP with a wrong country code and its installed now. I tried changing the code remotely by first doing it on WLC, but the AP dissapears. Is it possible t...
Hello,I want to know what will be the behavior or xlate entries if traffic to a destination changes the outgoing interface due to a routing change. The xlate timeouts are set to its default value.Is there any automated way beside clearing the xlate t...
Thanks for replying, I am working with a Cisco Gold partner and we got this AP directly from Cisco. Does that mean we have to RMA the device for a proper one or is there any other way out.
Speaking or FRR, I have another question :)I have a circular topology( hub on the top) and Primary one hop tunnels to the adjacent left & right node. I also have backup tunnels to these left & right nodes through the opposite direction (for FRR).My q...
Hello,I am confused, if I don't enter the following command under the tunnel interface :tunnel mpls traffic-eng bandwidth but configure IP RSVP bandwidth command, what will the bandwidth requirement to setup this tunnel, or if the tunnel is up what b...
Hello,I need to know how ME 3400 switches C-VLAN created on different ME switches. Is it through the S-VLAN (CE port is q-in-q), same as that of a normal layer 2 switch.
