Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
From where to download the cisco images (Router and L2,L3 switches) for eve ng and which image will work good.Below is the list mentioned in eve ng but what is the proper way to download these imagesDynamips (Cisco IOS emulation)c7200-adventerprisek9...
Hello Team,I tried using the attached method to physically reset the access point in order to forget the known WLC IP list, but it didn’t work. The AP is still attempting to join the WLC that I don't want it to join via the known list.Could you pleas...
Hello Team,Could you please advise on how to reset a 9120 access point so that it forgets the known WLC list only? I should not lose AP image.Scenario:My 9120 AP is attempting to join the 5520 WLC through option 43, which is not compatible. I have up...
Hello All,Could someone please share me the csv file format that is used in location feature which I can use to assign tags to APs using access point MAC address.Please also share how I can add more access point to this newly created location later u...
Hello Guys,Could someone help me with the root cause of the below ISE Radius logs all wireless users for one particular site. It shows in loop till the TLS timer expires12505Prepared EAP-Request with another EAP-TLS challenge 11006Returned RADIUS Acc...
Hello All,After clearing the lease, appling the option 43 again from scratch and restarting the DHCP services, the AP joined the WLC.It seems that option 43 was not taken by AP the first time. A DHCP service restart was required after the modificatio...
Hello Simon,What is the difference between holding the mode button for 20 seconds versus 30 seconds during a reset? Also, which method should I use for the purpose I mentioned in my main question?Out of 4 new APs only 1 joined properly (All APs are s...
Thank you for your reply.However, it's still a bit unclear to me.What is the difference between holding the mode button for 20 seconds versus 30 seconds during a reset? Also, which method should I use for the purpose I mentioned in my main question?
Hello JPavon,Thank you all for in detail reply.Could you please share me the channel utilization threshold for 2.4Ghz and 5 Ghz post which users will start facing issues.
