Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My call history report native to the CME is "Stuck". I cannot clear it and it hasn't been updating call records since April 6th, 2016.Does anyone have any ideas on how to clear these records? This is on a 2911 router, CME 10.5/CUE 8.6.12 and about ...
Can someone please tell me what the differences between these two commands are: service phone daysBacklightNotActive 1service phone daysDisplayNotActive 1 We have 7945 and 7965 model phones. What will the effect be using one or the other of these co...
We had an issue very much like this. We tried everything under the sun to make it work. Then in frustration one of our Field techs decide to read the FAX manufacturer's manual. Come to find out, the FAX machine itself had a setting in it for servi...
I have several Cisco CME (10.5) on 29XX routers with remote VG310 units serving analog dial-tone to remote FAX's and analog devices. I would like to install a 4-port FXO card in the remote VG310 so the Cisco CME can receive incoming analog trunk cal...
This entire setup I fully understand and have set up and used for years but I have a system that froze on April 6th, 2016 and no matter what I do I cannot remove the call records and they will not update or record new call records. I have adjusted m...
No, we don't use anything like that. It is not on the per phone basis that I am having the issue. It's the actual call history report in the CME GUI that I cannot clear.
Can someone please tell me what the difference between these two commands are: service phone daysBacklightNotActive 1service phone daysDisplayNotActive 1 We have 7945 and 7965 model phones. What will the effect be using one or the other of these com...
