Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As part of a new implementation, I have the requirement to interconnect a vPC Cluster of Cisco Nexus N9Ks (peer-switch/peer-gw enabled), with another pair of third-party multi-services platform running [for the purpose of this analysis] as a pair of ...
Using meraki MX68 just as gateway for routing and monitoring (no VPN)I am deploying an Starlink internet service in a remote location. In the first stage, we want to test it and monitor it to be able to measure its health and stability.In such scenar...
Hi,While configuring enhanced object tracking with IP SLA icmp-echo leveraging track lists, I understand that each object is completely independent from each other in terms of timings (frequency), states, etc.Since each tracking is bound to an ip sla...
Thanks for the information, I will check-out the article.In the MST implementation that you are suggesting, the MSTP on the Cisco devices, would be implemented on a per-interface basis?
Thanks Balaji.After reading the guide. I also understand that in the afore mentioned scenario, the appliance will be able to connect to the dashboard just fine (previously having configured the serial and so on at the dashboard), and then monitor the...
Hi Luis,thanks for such good and clear article. In an scenario where we already have one operational unit (WS-C3850-48P) and we want to add a second one (new unit also WS-C3850-48P) in a stack-wise set-up.I understand, that as long as we meet the bel...
Hi Mohammed,With respect to the way 2 -
network
command.I understand that besides having the 0.0.0.0/0 route is present in the Interior Gateway Protocol (IGP) routing table, rather having it
(the default route)
defined as a valid/functional
static r...
