Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
We are using Cisco ISE in our environment, branch offices try to authenticate using RADIUS, and the packets are 1800 byte large, this leads router to fragment the packets. Since the fragmented UDP packet do not have header, it disturbs the qos...
Hello,
I would like to know pros and cons of going through Cisco Prime for ISR waas installation on a cisco 4331 router.
Has anyone managed 100s of ISR WAAS devices deployed on ISR 4331 routers through Cisco Prime?
I did install a lab device but I ...
Hello,
I have a cisco 4331 router where I need to upgrade OS to higher version. Current version:
#sh version Cisco IOS XE Software, Version 16.06.02
I have OS for version16.6.3 in the bootflash and have changed the boot marker but when I reload the...
Hello,
I have a C3650 switch (call it switch A), it connects to another C3650 (switch B)which is configured as layer 3 with ospf on it.
Switch A connects to 3 layer 2 4500 switches, nothing else is configured on this switch A except for loopback addr...
Hello,
I have a C3650 switch (call it switch A), it connects to another C3650 (switch B)which is configured as layer 3 with ospf on it.
Switch A connects to 3 layer 2 4500 switches, nothing else is configured on this switch A except for loopback addr...
R1#sh bootvar BOOT variable = bootflash:,1;bootflash:isr4300-universalk9.16.06.03.SPA.bin,1;CONFIG_FILE variable does not existBOOTLDR variable does not existConfiguration register is 0x2102
Standby not ready to show bootvar
R1#sh verCisco IOS XE Sof...
Thank you everyone for your support and suggestions.
I brought up connection using SVI and then configured ospf.
This community is amazing, thanks so much
Thanks for replying guys.
There is no management SVI configured.
Only thing configured is loopback, this particular switch connects to another switch on trunk port and this another switch has ospf and routing to outside.
Can I just advertise loopback...
Is your problem resolved now?If not, go to Quality of service > advanced mode > policy binding and delete the access ports of the switch.Restart outlook and then try, it should work.
