Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have installed CUCM 7.0 in vmware and details is configured as follows:Host Machine: Windows XP : IP Add - 192.168.10.69 : Subnet Mask - 255.255.255.0 : Gateway - 192.168.10.119Guest M...
Dear All,I am beginner in voice and I need help to configure Dial-peers on cisco routers.between two router i can configure dial-peer and calling is successful but whet i create a scenario with multiple routers like Router R1, R2, R3 and R4.all route...
Dear All,I have a 2921 ISR-G2 router in working condition. I configured the router first time and log out without changing the password and in ISR-G2 it is must to change the password before logging out.now it is not allowing me to login again.plaese...
Dear All,Could you please help me to get this query answered.I need to know if we order 3900 series router so will I get the licenses pre-loaded or hard copy (CD)?If this is written somewher please share.ThanksNitin
Dear All,I have 3750 switches as core switches and 2960 switches in my network.Now I need to configure my network for Dynamic VLAN .I have checked the 3750 configuration guide and as per the document I found that, we cannot configure 3750 and 2960 sw...
Thanks for replyI cant ping any internet ip address though I can ping my gatway. same configuration in on my windows machine and everything is reachable.I think this issue is in UCCM dns configuration or VMWARE. but if I create another guest machine...
Thanks for the reply.Still I am not getting success to call from R1 phones to R4 phones. with only two routers there is no issue.with 4 routers as u r saying there is no need to configure anything expect IP reachability on R2 and R3, but I think once...
Thanks Ganesh for your valueable information.Could you please also help me to get the resolution for the below query.We have ordered a 3945 router with UC, Data & Security license but we forgot to add FL-SRST & FL-CME-SRST-100 licenses.now router is ...
