Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would like to monitor CPU util. on a 3850 stack (4 switch stack) using Cacti.
I have tried using the standard Cisco CPU template, but for the 3850, this does not return any values.
I have browsed the device with a MIB browser, and have identified t...
We are running ISE 1.4 across our campus network, currently with a mix of MAB and dot1x authentication (migrating all devices to dot1x is moving slower than expected), and have come across an interesting issue with a new batch of Polycom conference s...
Briefly, we have several external CCTV cameras connected to a specific vlan across our campus network. These ports are setup for dot1x, and we push a dACL down to the port based on MAC addresses (certificates cannot be loaded on these cameras). A mem...
We are in the process of moving from LMS4.2 to PI 2.0.Does anyone know if automated actions (LMS4.2 ---> Admin > Network > Notification and Action Settings > Syslog Automated Actions) exist in PI 2.0, and is so where can these be configured?I basical...
Last week I setup PI 2.0 on an ESX server using the OVA template. I can access the PI through the WebGUI without issue.Because of our network topology, I need to use 3 interfaces to properly manage our environment. Through vCenter, I added 2 addition...
Works for me:
Gi1/1/1 CHBARSWHOOBS1/1.0. connected trunk full 1000 1000BaseSX SFPGi1/1/2 CHBARSWHOOBS1/1.0. connected trunk full 1000 1000BaseSX SFPTe1/1/3 CHZRHSWHBOOB01/1.1 connected trunk full 10G SFP-10...
We have 2 x 6120XPs connected to one chassis with 2 x 2208 IOMs running the newest code, 2.2.3. I have tried everything I can think of to create port channels between the FIs and the IOMs, but for some reason it appears that this cannot be done. Can ...
Just want to follow-up for anyone who might encounter the same situation.Keeping the VSL link intact did allow us to maintain the VSS configuration on the new chassis, although to synch the 2 chassis, following the installation of the new chassis, BO...
Just in case someone stumbles across this.Someone had configured:set dot1q-all-tagged enable on the 6509. This causes all native (untagged)packets to be dropped, so any communication over vlan 1, which is our management vlan, were dropped. This expla...
