Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would like to ask for confirmation and feedback on a C9800-CL design, given a specific infrastructure limitation.BackgroundWe are migrating our wireless infrastructure to a new Hyper-V cluster.This cluster has a limitation: it does not support 802....
I have an Azure Stack HCI (Azure Local) cluster consisting of two servers: Host-1 and Host-2.On Host-1, I’m running WLC-1 (C9800-CL) and a Windows VM (VM-test1).On Host-2, I’m running WLC-2 (C9800-CL) and another Windows VM (VM-test2).Both WLCs use a...
Hello, I need to configure my BE6000 for the following needs:
- External users call a specific internal number (e.g. 001345666). Is just one, can I use the hunt pulit the same?
- If 5666 is busy (on conversation), external users must hear a recordi...
Hello everyone,
I've some Cisco IP Communicator devices configured on my CUCM 10.5.
Every CIPC is identified by device name (SEP<MAC ADDR OF THE PC>). So when I open the CIPC software, CUCM doesn't require any kind of authentication.
I w...
Hello everyone, I've CUCM 10.5 with CUBE router.
I've configured an hunt pilot (4444) for a little inbound call center. When an available representative answers to the incoming external call, all works well.
The issue is experienced when the external...
This was not possible because on Hyper-V, with NICs that support SR-IOV, it is not possible to use the mandatory MAC Spoofing mode (which in ESXi is called Promiscuous Mode).
I discovered the problem. When configuring GigabitEthernet2 on Hyper-V with the following command:Set-VMNetworkAdapterVlan -VMName WLC-1 -VMNetworkAdapterName WLC-Trunk -Trunk -AllowedVlanIdList "2-4095" -NativeVlanId 1an event log message like the f...
Sorry Mark, how can I send you the Analyzer full report? I don't want to attach it here, because maybe it contains sensitive informations.thanks a lot for your help
