Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to implement QoS to improve voice quality on our network. We are a Cisco shop. The switches are 2950's and 3750's and the routers used ranges from 2800's to 3845's. Should I implement AutoQoS or configure QoS manually? If Autoqos is suggested,...
Do you see the serial module when you perform a "show ver" or "sho run" command? If so, you need to know whether to configure for frame-relay or full T1 setup. You also need to find out the type of encapsulation the ISP is using on their end. I do no...
For load balancing, Cisco have a couple load balance appliance (CSS11501 and CSS11503). There's a module you can buy for 6500's series switch called a CSM.
