Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 Cisco 9500 setup in virtual stack and its been working since 2019 with no issues. This past week it stopped working properly and now I see when I do a show stackwise-virtual dual-active-detection pagp the below. I'm not sure why only 1 por...
When users attempt to reset there own pin in the messaging assistant they receive Access to the requested resource has been denied.
The attempted action was a violation of security protocols and will not be allowed. Please try another action.
In th...
When connected to our VPN some of our corporate applications that are access across the WAN from our office location timeout over http/https they work fine in the office. The ping times in the office are in the 30-40ms range and over VPN jump to aro...
So in my setup I have a disjointed network setup Vlan 1 is my core business and vlan 902 is for my iSCSI I have no issus connecting to vlan 902 and the blades themselves I have been able to have connect to the Vlan 1 uplink properly. I have Vmware E...
I am getting the below error when I create a service profile and click finish.
failed creating service profile service profile (profile name). Property order of ether-dynamic-vf-257 is out of range
I'm sure that I did something wrong but have not...
For both sh pagp x neighbor, and sh pagp 1 counters I get no interfaces configured in the channel group. The 4 interfaces are each configured with channel-group 3 mode desirable I did remove and re-add the config on all 4 ports and did a reload on...
The cables are secure, and I have tried to swap out the GBICs, and the cables, also all for of the physical interfaces show up, up though the port-channel shows down and not connected which is odd with the physical ports up
MorCISNetCore#sh pagp internalFlags: S - Device is sending Slow hello. C - Device is in Consistent state.A - Device is in Auto mode. d - PAgP is downTimers: H - Hello timer is running. Q - Quit timer is running.S - Switching timer is running. I - Int...
Well redesigning the network isn't really an option right now since this is a production environment and the vlan 1 was defined for it a long time ago by someone else.
I seemed to have solved my issue it wasn't quite at the Cisco level in the vm ho...
