Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, I'm new to the SG series switch. I am used to seeing a lot of output when using the "show arp" command, but on my SG500 I only see one entry. "show mac address-table" shows me all the L2 information, but why can't I see the L3 information ...
I have a setup of two L3 switches and one router. Am I missing something very fundamental here, or this is a GNS3 error? Thanks in advance for any help!I can ping from 10.99.99.3 to 10.99.99.1 and visa versa. However, I cannot ping from 10.99.99.3 to...
Here is a section of my BGP lab inside GNS3:My issue is not being able to ping anything on R5 from R2 even though R2 is recieving the routes from R5 and has placed them in it's routing table.Thanks in advance for any help or advice!-Steve************...
I am studying route summarization and am having an issue with my remote router automatically marking a route as default. Thanks in advance for any advice! Please advise if you require more settings from either router.Local Router:First I created a lo...
Hey Cisco community, I'm going through the CCNA training and I'm setting up my DHCP server on my 871 router. I have my cable modem into the WAN port on my router and have 1 host plugged directly into Fastethernet 1. I can ping any IP I want from the ...
Thank you very much for your response, I was able to get the lab to work by adding:R2ip route 10.1.99.1 255.255.255.255 10.1.24.2 2R5ip route 10.1.24.1 255.255.255.255 10.1.99.2 2So now my question is, why? R2 knows the way to get to R5 is by going t...
Peter,Thanks so much for your reply. It's nice to know I had the config correct, and it was an issue of out my hands.In regards to my IOS I am not running:Local: C3560 Software (C3560-ADVIPSERVICESK9-M), Version 12.2(37)SERemote: C870 Software (C...
Wow, thank you so much John! It fired right up!If its not too much to ask, is there any way you could explain each of those commands? It would help out greatly in my quest for the CCNA.Thanks !Steve
