Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to figure out a problem with regard to EIGRP and static routing and using a route-map policy to inject specific static routes into EIRGP. We have a corporate router and about 24 remote locations connected via frame and a small group connec...
I would like to know if its possible to create a site-to-site VPN tunnel with a Cisco 1841 router with IOS 12.4? If so could someone guide me to resources that would help me with the configuration? If it makes a difference the other end of the tunnel...
We are going to implement a 4402 WLC and light-weight APs on our network. Our network is basic with windows servers and windows XP clients. The wireless network will be used by our users for local resources and our guests for access to a broadband se...
We are planning on installing a WLC 4402 and about a half dozen 1131 AP on our network and over time about 6 more APs will be installed. The WLC and APs will be connected to a new HP switch which supports VLANs but not layer 3 switching/routing. Our ...
My situation involves two locations, one is a corporate location and the other is a remote office. The corporate location has three T1s multiplexed to a frame cloud so there are multiple sub interfaces on the one serial card for remote office locatio...
Thank you for the fast response as your replies helped me understand what the first line of the access list is doing. Sorry if I didn't clarify the problem I'm having. I see that my problem is I cannot ping the networks in access-list 1 from the remo...
Thank you for the reply as your information was a big help. I bought the book you recommended and it has been a great help with understanding the security confusion.Thanks again,Jeff
Rick,Thanks for the reply. We are using dynamic routing and below is what is configured on all the routers inlcuding the two I will be using for this situation. I'm not sure what change should be made to adjust the metric.Any help would be appreciate...
I now understand what I need for the one circuit which will be used exclusively by the two servers but will I need a route-map configuration (PBR) for the other circuit which will route all the other traffic?Thanks again,Jeff
