I have not seen a way to pull a list of disassociated APs directly, and am not sure the WLC tracks t...

I can't speak for LDAP specifically, but if you use RADIUS (MS IAS is free), you can define the Cisc...

I am not sure there is a good way to answer that question. Cisco has made it clear that 5.x is not c...

Yes, you can specify the native VLAN, though I am not sure if that will enable tagging of that VLAN ...

Depending on if the switching hardware supports it, you could use the command "no switchport trunk n...

fella: I'm curious your reasons for static IPs on the APs. Care to elaborate? I have done many deplo...

I personally would choose option #3. Use the DHCP solution you use for clients. Typically networks h...

Goen: Due to the nature of duplex negotiation, if you force one side and not the other, you are VERY...

We had some significant issues with MFP with Intel clients. We did not track down the root cause, bu...

WPA-PSK (Personal) has some public methods to crack. If it is a dictionary word it is relatively eas...

I'll give this a shot:1. You should not be able to ping the AP-Manager IP. That is expected.2. This ...

It can't, but most stats you might want can be gathered from the controller. If you let me know what...

Have you checked what power level it is currently set to? It is possible, though unlikely, that the ...

Can you do a "show diag" and "show ver"? It may help us see any issues.-EricPlease remember to rate ...