bjorn.tegelberg
Beginner
Beginner
Member since ‎03-08-2016
‎09-13-2020

User Statistics

  • 9 Posts
  • 2 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
CCP Member
1 Accepted Solution

User Activity

We have used the In-Room Editor to create panels for Audio Call, TV and Video Conf. Crestron is using the Panel ID's to allow us to use the Touch 10 display to change source, turn off the TV etc and this works fine. We can control all this from the T...
We have SNR (Single Number Reach) setup and it is working with incoming calls going to both the IP Phone and Mobile Phone. However, as the extensions are members of a Hunting Group for the office using Broadcoast, this creates a big problem as the mo...
When users log into the Self Care Portal and add Speed Dial Numbers they do not populate on the phone. Self Care Portal version 10.5.2Cisco IP 7841 phones After adding a number in the portal, we get 'Not assigned' on the IP Phone when going to Speed ...
About once every minute a new entry is created, which fills up the Voicemail mail (10,000+ entries!)From: Cisco Unity Connection MessagingSubject: Message from Unknown sender (Unknown caller ID)Duration: about 19 secsMessage: If you want to turn off ...
Is there any setting to control incoming calls to an hunt group not to ring on the remote destination (mobile)?We have a setup where all extensions for an office are part of the hunt group. Recently routing for remote destination (mobile) was added, ...
Community Statistics
Member Since ‎03-08-2016 05:45 AM
Date Last Visited ‎09-13-2020 11:32 AM
Posts 9