Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,
Installed and configured Cisco DNA in Airgap environment with version 2.2.2.4
After a power outage, there seems an error saying that the " Automation and assurance services have been temporarly disrupted. The system is working to restore thi...
Hi Team,
As part of installing DNA in Airgap environment, Version 2.3.3.3 2nd generation appliiance, the network wizard is failing the ping test to the default gateway.
Process - Selected DNA advanced configuration -- provided ENT IP address in ENT ...
Trying to convert 1572E from lightweight to autonomous but not working. Configured and IP in ethernet port and bvi interface. APac3a.6744.a720#ping 10.1.1.1Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.1.1.1, timeout is 2 seconds...
Planning to implement a wireless network having 1572 series access point, which will be having both omni and directional antenna. In a single AP, shall we connect 1 x air-ant2513p4m-n=(directional antenna) & 2 x AIR-ANT2568VG-N=(omni antenna) to serv...
Hi
I am in middle of an implementation of FTD and FMC
I am facing an issue with the interfaces in FTD. We have 2x2140 devices which is added to FMC with the management interface. Connected a 10G port to core switch and it came up but rest all ports ...
Hi Tony,Could you please give a bit more clarity in your statement "Antennas connected to "one radio" shall have same type and orientation. It's not recommended to cover different areas, with antennas pointing in different directions"If i connect 2 x...
Hi Leo. Thanks for the response. If we have both omni and directional antenna. So as mentioned above, if we connect 2 x omni antenna on the below ports and configure it for 2GHz and connect the directional antenna on the AP top side ports to configur...
Hello,Please goto Configuration --> Radio configuration --> Network. There will be a status box for both 5 and 2.4 Need to click the box to check it and then the radios will be up.Thanks.
