usaf_27

Under “Create a Floor Map Using an Ekahau Project File” it specifies the version of Ekahau. Also per...

Ekahau version 10.3 is not supported. Try version 10.2. 

Ekahau version 10.3 is not supported. Try version 10.2.  

There is also another interface on the appliance for Internet Only access. Anyway to DMZ that off to...

You should look into the Cisco 40G BiDi SFP’s. You only need 2-Strands of fiber to achieve 40G. QSFP...

Do you have “Device controllability” enabled?

How is your credentials being used? Is it being authenticated by TACACS? I also suggest you turn on ...

The 9800 controller has has nothing to do with how DNAC is updated. I have done many DNAC system upg...

Here you go. Run this. Some commands may error out. But this will completely wipe your switch to a f...

With very limited info I am suspecting you have a Config present on the switch. Trying clearing the ...

All you gotta do is change the duplicate name of the AP that is currently on the controller. The AP ...

Just got word this feature will be out in DNAC version 2.2.2.x. Expected end of April.

Hello all. Will DNAC reconfigure an AP's controller IP Address when re-assigning it to anther site? ...

The link you provided only talks about the controller itself. It does not mention anything about DNA...