Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have an MX64 connected to the internet with 2 uplinks. One of them is a metered connection so I do not want client x to use the specified internet connection. But other clients can use both of them.How can I configure this configuration? I know y...
Hi
I'm configuring a VTI tunnel from a Cisco 881W to a Juniper SSG550. The tunnel will be terminate from a vrf named factorywl. To make the whole thing more exiting the Cisco will also be using DHCP to receive an IP address. Since the Cisco uses a DH...
HiWe have a door that is opened using an analoge phone line (if you hit # on the other end it should open). The lock is connected to an ATA186.When the call is routed out of our CallManager and to the PSTN pressing the # in the other end works perfec...
HiI'm finding it hard to create groups in AD and have the diffrent groups in AD assigned to diffrent roles in Cisco LMS 4.1Is it possible to have diffrent AD groups to assign the diffrent roles in LMS? If it's possible how should I do it so it work a...
HiJust discovered a way of solving this issue. I used NAT exceptions for the VLAN the device was conected to. That was the only way of getting this to work.If I turned of NAT on the interface that I do not want the client to connect trough the traffi...
HiThanks for the reply, it seems like it is not possible to block access to the second WAN connection. This connection is a sattelite connection also so the amount of bandwidth varies.This is so far the biggest drawback for me with Meraki :'(
