Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am in a situation where I have 3 locations:
Location A: 192.168.1.0/24
Location B: 192.168.2.0/24 -Cisco IOS Router (the device I control)
Location C: 192.168.3.0/24
Location has a site to site vpn with Location A and B, however I now need to setup...
I have an ospf conenction that is stuck in EXSTART state between a Nexus and an ASR. I already put in the ip ospf mtu-ignore on both the ASR interface and the Nexus interface, however it is still stuck in EXSTART. I am also not seeing anything on t...
I doubt that this can be done without contacting the isp, but a traceroute to my network shows the isp private ip addresses. Is there anything I can do on my ASA to still keep traceroute alive but block the private ip addresses?
I am currently running a Cisco ACS 5.4 and am looking to upgrade to 5.8 so I can utilize the feature to schedule reports and send an email out.I am aware that I would have to upgrade to either 5.5 or 5.6 first. My concern is that we currently have cu...
I have a cisco router and behind it is an asa 5505I had to blow out the config from my router and recreate it due to a major blunder on my part so I have everything up and running however for some reason my asa cannot ping the outside, but it can pin...
YES the ASR has it in a VRF and the nexus has it in a a global
YES the Port Channel is using VPC to another NEXUS, but I am only trying to join this 1 NEXUS to ospf using that 1 port channel interface
I am not allowed to post the whote config I can show the interfaces though:
intterface Vlan103 no shutdown ip address 10.51.103.249/24 ip ospf authentication message-digest ip ospf message-digest-key 22 ip ospf cost 101 no ip ospf passive-interfa...
BrandonI split my peers and now I am able to make outgoing calls. I am having an issue with incoming calls. Below is my debug for the incoming call, as you can see it matches the dialpeer but I get the feeling there is something I am missing:VOICER...
