Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When i am trying to configure the ERSPAN Protocol on below Cisco Model but i am not getting any configuration option only traditional configuration option is available which is SPAN. Model SW Image ...
Hi, I have a question. If there is a DR, then LSA type 2 will be sent to all other routers, but why is DROTHER also sending individual LSA Type 1? I understand LSA Type 2 a little bit, which is that it is used to obtain the information of the router ...
Hey while working on the EIGRP i have came across a topic of unscaled eigrp metric. In my topology my router is using classic metrics and wide metric but how this formula will work can someone help me out with this problem. ???
During EIGRP neighborship form process both router exchange the update packet and first packet is init and second update packets contain the routes. But my doubt is first R1 has send a update packet on multicast and then again it send unicast in the ...
Hello everyone,While learning EIGRP, I encountered a challenge regarding metric calculation. I understand that each router calculates the Feasible Distance (FD) to reach a destination. As part of this process, each router first calculates the cost to...
This is the topology where two transit area are there so according to this topology when i check the ospf LSDB Database then i am able to see all router LSA Type 1in R1 LSDB. So my question was that if all routers are sending LSA type 1 to each other...
Suppose that there are 5 Router. R1 R2 R3 R4 R5 R6 they are in multi access network and R1 AND R2 are DR AND BDR. There is one more router R6 which is not the part of this multi network access which is directly connected to R1 via serial cable so my ...
