Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
As describe in the title, after a reboot of a stack (2) of 2960 switchs, the dot1x authentication on access port isn't working.
The authentication is still working on other switch.
Find the configuration below:
aaa new-model
aaa authentic...
Hello, I have 3 SFP modules inserted into a stack of thow 2960x, and only one SFP module is detected, the 2 others are show as unknown. The "show version": sh versionCisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Version 15.0(2)EX5, REL...
I have a snmp trap sent every 30 seconds from one of my cisco switches (a stack of 3750 to be precise): ccStatusMemberStatusChange Do you know what it is and why it is sent continuously?? Thank you for your answers. Flo
Hello, I have 2 AP 1250, and I want to set the second as repeater with the 1st as root.But it doesn't work, I see two messages on the "repeater": Sep 16 11:10:19.772: %DOT11-4-CANT_ASSOC: Interface Dot11Radio0, cannot associate: No Responseand : Sep ...
No the speed and duplex are not hard code. Find the configuration of the interfaces below Current configuration : 224 bytes!interface GigabitEthernet2/0/49 description B-Server switchport mode trunk switchport nonegotiate spanning-tree link-type poin...
The sfp model is GLC-SX-MM. The one that works:GigabitEthernet2/0/49 is up, line protocol is up (connected) Hardware is Gigabit Ethernet, address is bcf1.f2d6.8831 (bia bcf1.f2d6.8831) Description: B-Server MTU 1500 bytes, BW 1000000 Kbit/sec, DLY...
