Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
*Jul 17 10:31:35.615: %FABRIC-5-FABRIC_MODULE_BACKUP: The Switch Fabric Module in slot 4 became standby*Jul 17 10:31:42.439: %OIR-6-PWRFAILURE: Module 5 is being disabled due to power convertor failure. PMB registers are dumped as follows, R0= 0x0, R...
Hi ! I have stack of 4 Switch 3650 when ever the power goes and come back the switch goes in Switch mode i manually need to boot the Switch , i have tryed to erase and load new IOS still the problem exist.
How to recover switch in stack (one of my ...
Dear Friends,
I have Cisco Dx80 i need to upgrade Firmware. i have given cisco Tftp address 128.107.1.157 .
my device is not getting upgraded. pls help me with alternate way to upgrade the device it is very URGENT.
Thanks & Regards
If the switch is not getting stack just because of the IOS version.There r 2 options to get in the stack.1) Remove the switch from a stack and upgrade it to the same version of the master switch.2) If u don't want to remove from stack run the command...
Dear Manish,
Thanks for your reply i have downloaded this is file inmy labtop and make my labtop as TFTP server , still it dont take file from my labtop tftp server all antivirus and firewall is disable i can ping each other.
I use another meth...
Dear Mr.Aman,
Thanks for your reply . I got only the device as the cucm is in another countery so i have no idea
I have 10.2.3 version need to upgrade it to 10.5 to get express way working.
Thanks
