cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
564
Views
0
Helpful
3
Replies

The card in slot 5 has reached the maximum number of 5 restarts, this card will be disabled

*Jul 17 10:31:35.615: %FABRIC-5-FABRIC_MODULE_BACKUP: The Switch Fabric Module in slot 4 became standby
*Jul 17 10:31:42.439: %OIR-6-PWRFAILURE: Module 5 is being disabled due to power convertor failure. PMB registers are dumped as follows, R0= 0x0, R1= 0x3, R2= 0x3, R3= 0x0, R4= 0x0, R5= 0x7, R6= 0x0, R7= 0x0, R8= 0xF, R9= 0xF, R10= 0xD, R11= 0x0, R12= 0x0, R13= 0x0, R14= 0xA, R15= 0x0
 
*Jul 17 10:31:42.659: %C6KPWR-4-DISABLED: the power to module in slot 5 set off (FRU-power failed)
*Jul 17 10:31:42.659: %OIR-4-RESTART: The card in slot 5 has reached the maximum number of 5 restarts, this card will be disabled
 

3 REPLIES 3
Leo Laohoo
VIP Community Legend


@Shaikh Maula Madhar wrote:

*Jul 17 10:31:42.439: %OIR-6-PWRFAILURE: Module 5 is being disabled due to power convertor failure.  


Contact Cisco TAC and arrange for an RMA.  The line card in slot 5 is failing.  

The card which is replaced is RMA done and it is new , 

*Jul 17 11:36:11.251: %OIR-6-PWRFAILURE: Module 5 is being disabled due to power convertor failure. PMB registers are dumped as follows, R0= 0x0, R1= 0x3, R2= 0x3, R3= 0x0, R4= 0x0, R5= 0x7, R6= 0x0, R7= 0x0, R8= 0xF, R9= 0xF, R10= 0xD, R11= 0x0, R12= 0x0, R13= 0x0, R14= 0x8, R15= 0x0
*Jul 17 11:36:11.519: %C6KPWR-4-DISABLED: power to module in slot 5 set off (FRU-power failed)
*Jul 17 11:36:11.527: %OIR-6-PWRFAILURE: Module 6 is being disabled due to power convertor failure. PMB registers are dumped as follows, R0= 0x0, R1= 0x3, R2= 0x3, R3= 0x0, R4= 0x0, R5= 0x7, R6= 0x0, R7= 0x0, R8= 0xF, R9= 0xF, R10= 0xD, R11= 0x0, R12= 0x0, R13= 0x0, R14= 0xA, R15= 0x0
*Jul 17 11:36:11.759: %C6KPWR-4-DISABLED: power to module in slot 6 set off (FRU-power failed)