Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, This one has stumped me for quite some time - long enough for me to go to the effort of actually doing some documentation! In a pinch, I need to do hairpin NAT from the internal VLAN 1 hosts, to the external NAT addresses on two of the link...
Hi,I've got a 2851 running 12.4(11)XW5 where I run CallManager Express, some IP accounting and NAT.Unfortunately while it all works painlessly, SSH sessions will timeout after idle inactivity going out of the NAT interface to the outside world. The ...
Hi,I have a Cisco 877 where I wish to have an IP phone behind a NAT gateway and a CM cluster which is Internet accessible and I cannot hear the called party but they can call me. Has anybody done this before and could advise what settings I could us...
Hi,I have an IP phone behind a NAT gateway which is registering with a CM 6.1 system (which is on a public IP).I have added ip inspect rules for the following:ip inspect name voip rtsp timeout 5ip inspect name voip skinnyip inspect name voip h323ip i...
Hi,I've got a 2851 which functions as a NAT gateway to the Internet as well as running CME 4.1. While I can register phones internally without any trouble to the internal IP, I haven't been successful with doing so to the external global IP on the N...
I logged a TAC case about this yesterday. This is the best way of highlighting to Cisco that there is a need/demand for documentation when the software is released.
Hi,Unsure if this is solved, but I've hit this recently. The TL;DR, you need to go to 17.5.1, then 17.6.8, then 17.9.6 or 17.12.x, and then the desired later release if you are targeting 17.15.x.Your image appears to be some sort of bootloader imag...
Hi all,Did anyone get to the bottom of this? Is this configuration supported with guestshell? I've configured similar on 17.15.1 using similar config. I can see the IP in the ARP table with the correct MAC address, but not in the MAC address table. ...
A follow-up observation - I find that if I reload the box, the fans speed up and stay high, but if I power cycle, the fans remain low.Try power cycling and allow the unit to boot up again and then observe if there's any difference between that, and t...
Interesting observations! Would be interested to know if the -c and -f models you have encountered use different fan models or not. It's not uncommon for vendors to use different fan vendors etc in different hardware revisions.Is there any difference...
