Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
WE have an existing FMC which is managing cluster of FTD for our main site. Now I have 2 new FTD I want to add to FMC as HA cluster. What are the steps to do add the new FTDs to the FMC and then create a completely seperate policy for the new HA clus...
what is the upgrade procedure for FTD A-A cluster via FMC cluster. First doing such upgrade in live environment.FMC version > 7.4.2.1 to version 7.6.2-329FXO version > 2.14.1 to version 2.18.0.520Below are the files downloaded from Cisco:Cisco_Secure...
We have ASA module in 6509-E with ASA ios version 9.0.4 & 6509-E ios version 15.5.10.Multiple DMZ's exists on the ASA and from one server hosted in 1 of the DMZ's which initiate NMAP scan to all the hosts in the network. So the traffic path is NMAP s...
I am seeing IP Address 127.0.0.x is being discovered in our NAC solution generated from C6509-E with SUP2T and the IOS version is 15.5.1SY10.Is there any specific command to display from where this ip address is being generated on the VSS switches?
I am trying to configure an automated backup of the configuration on a daily basis from various cisco devices.I have tried the KRON & archive methods without any luck.Is there any valid document on this subject with examples?Switch# config tSwitch(co...
I want to add the 2 brand new FTD as another cluster on the FMC.FTD 3110 version cisco-ftd.7.4.2.172 FXO version 2.14 and FMC 2700 version 7.4.2.No NAT at the moment and Do not want to have strict separation as the admin's are the same.
I have executed "show tech-support" along with the full configuration file for "127.0." with NO luck.Also, I have checked the arp table, cef, ...etc. 127 is not there which why i am confused from where this ip is coming.
@Knassi You can use SFTP or SCP with the archive & kron method.Notes:Version 17.1 and earlier will support both but the SSH algorithm supported is only SHA1, so you need to make sure that your SCP or SFTP server accept that algorithm.Version 17.2 and...
