Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm searching an update table which provide information about NAT feature support in Catalyst switches.I would like to know if the Nexus 7000 support NAT but my table below is too old -> Updated: Apr 05, 2006.From my research, it's not possible bu...
Hi everybody,I have a trouble with a switch (switch 1 master of 3 switchs in one stack) that is rebooting continuously when i connect a machine on it.Historic:I rebooted the stack because of electric cut.After startup completed, the switch 1 master...
Hello,I have several 5510 and one 5520 and I would like to know if it's possible to restore ASA 5520 config to ASA 5510?If it's possible, i will only need to have one 5510 in spare.After research on this forum, the reverse is possible (5510 to 5520)T...
Hi,Is-it possible to configure NAT on Cisco Catalyst 4506?I'm used to configure NAT on Firewall ASA but never on Cisco Catalyst 4506.After research, it does not seem to be possible.http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note091...
Hi,I have a question regarding the number of security contexts on my ASA 5520.On my ASA 5520, I have the licence for 2 security-contexts but I have a third context "admin".Is this mean that it's two contexts in addition for a total of three? Thanks i...
Hi,No I downgraded the switch to member onlyI deleted all the configs and the flash was empty.I copied a new IOS to the flash in rommon mode with the command "copy xmodem flash:"...I set boot flash with this IOS.I configured basic configuration with ...
Hi Leo,Thanks for your help.I deleted files about crash info in the flash to free space and the switch can again write crashinfo.But the swich is still rebooting...All my switchs have the IOS version 12.2(52) SE and I didn't have any trouble before ...
