Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm trying to find a way to enable 802.1x authentication on switchports that are using non-Cisco VoIP phones. These phones don't support 802.1x themselves and need DHCP access to the Primary VLAN to learn the correct Voice VLAN ID. I thought the...
Hi,I'm looking at setting up a large scale (1000+) client VPN system and I'm trying to understand the new QoS capabilities of dynamic VTIs. From what I have read, I believe I can setup both inbound and output service policies for each VPN user. What ...
According to the documents I've read regarding dynamic VLAN assignment, a user can be assigned to any VLAN via RADIUS. Does the AP have to have to the VLAN manually configured on the AP's Fast Ethernet?Is there any form of VTP available to advertise...
On a DPT/RRP ring do all routers around the ring see each other as being an identical distance apart?If two routers on a DPT/RPR ring advertise the same IP networks to the other routers around the ring by an IGP, would these other routers see the IGP...
From what I've read about these two commands I can't see any difference (in a L2TP environment anyway). Both will copy the PPP payload ToS byte to the L2TP header ToS byte where it can be used by outbound service policies. Is there any fundamental d...
Don't suppose you know what happens if you don't?It seems strange that you can have whatever VLAN ID's you want on the Wireless side without having to configure a sub-interface but have to do it on the Ethernet trunk...its not like there is really a ...
I believe the 2650 can run very limited MPLS however you should consider "VRF lite" if all you need is to run a CE router with multiple routing tables. I think VRF lite is available on most CE routers from 1700 series up...
No solution I'm afraid but a very similar question...The only QoS command for SRP/DPT seems to be the "srp priority-map" which maps IP Precedence to the SRP Priority. This can't possibly work with MPLS tagged packets so would the command use the MPL...
