Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the following velocity template I am trying to push when I provision a switch:#set($STACK_MEMBER_COUNT = $UX_COUNT + $P_COUNT)!#set($isStack = false)#if(${STACK_MEMBER_COUNT} > 1)#set($isStack = true)#end#set($firstMember = 1)#set($lastMember ...
I have a Cisco 9800 WLC running 17.12.5 and I have 1 central site (local mode APs where the WLC resides) and about 10 remote sites with APs in FlexConnect Mode and Local Authentication. Each remote site has a local authentication server with the auth...
According to the Cisco C1131X-8PLTEPWE, the embedded Wi-Fi support Wi-Fi 6 only but does it support WPA3. According to the datasheet it only supports WPA2.
We have a Cisco 9800-40 running 17.12.5.
We want to enable containment of rogue Access Points (not registered with the WLC or WLCs within the mobility group) broadcasting managed SSIDs or part of the SSID. We enabled rogue detection in the AP Join Pr...
I have a few questions relating to the new Cisco Custom RF ASIC on the 9K Access Points:1. Is the Cisco Custom RF ASIC also present on the 9176 Access Points2. Can the Cisco Custom RF ASIC be used to contain rogue Access Points and Clients without di...
I have opened a TAC and the issue was related to the shared secret length. Sites with a 64digit key did not authenticate with the local NPS when we change the key length to 32digit it worked
Hi Mark. I have analyzed the output of the command with the analyzer. The analyzer did not provide any issues relating to the configuration of the profiles. I also manually compared the various profiles and tags in the analyzer itself and they are al...
Thanks for the response....The Access Points are all registered to the same controller and 21 of the registered APs are classified as "Malicious" rogues. I have attached the list of APs registered with the WLC, the "Malicious" Rogue List, and the det...
Thank you for the response...I should rephrase the statement yes "default method list does not align with our client or our device hardening policies". I verified the commands exist on the 9K WLCs the current 9K switches are running 17.6.5 so we will...
