Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Team,We have a typical requirement from business to avoid outage at our datacenter.For your reference i am attaching a visio about current and future setup planning.We have man links between our data centers currently 2 X 10 Gig links running o...
Hello Team, We recently built Cisco ISE 2.6 virtual appliance, one of the business requirement we have is integrate/authenticate Viptela vEdge devices with our new Cisco ISE. I am new to Cisco ISE. I am not finding right document which shows the conf...
Hi Team, We recently built Cisco ISE 2.6 virtual appliance, one of the business requirement we have is integrate/authenticate Viptela vEdge devices with our new Cisco ISE. I am new to Cisco ISE. I am not finding right document which shows that config...
Hello Everyone,
Recently we have replaced Wireless access points at one our remote office from 3602 model to AIR-AP3802I-E-K9.
Post replacement we are unable to discover/monitor the AP's from NCS Prime. Does any one have similar problem ?
AP Model...
Hello Team,
We have a business requirement in capturing the Number of users connected per Wireless Access point.
Currently all our wireless AP's are LWAP associated with Cisco WLC 5508. When we are doing the SNMP walk to WLC we were able to capture t...
Hi Sergiu, Thanks for your quick reply..Just want to understand further on this part. Currently our devices are configured with Spanning tree MST. does this config automatically takes care. Also i would like to understand if the 10Gig interface is in...
Great presentation with very useful information.
I am working in a financial sector and one of the main concern is number of connection made to wireless access points. All our AP's are either 3702 or 3802 model with 5508 controller.
All AP's are in...
Hi Sandeep,
Thanks for providing the link, I have used the recommended OID but it is giving the client count information per SSID. But we are looking for Client Count information per AP.
