Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After attempting to install a newer system image, I receive the following output:Launching Bootloader...Default configuration file contains 1 entry.Searching / for images to boot.No images in /Error 15:File not foundUnable to boot an imageI can tftpd...
Hi all. I will be setting up vlans on cisco ap's for my wireless network. Each floor will have 3 ssids. One will be used for guest internet access. I can create vlans specific for each floor, or use the same vlan across multiple switches. Is the...
Just installed a 6509e and a 3560 switch in my LAN. Singlemode fiber is connecting the 2 switches using gbics. When moving data between the switches, transfer speeds get no higher than around 50mbps. Doing a sh int gig 5/1 produces the following. ...
I am trying to have users outside the network print to my internal printers. They can get to 10.234.8.x addresses on my end. I want to make 4 of those 10.234.8.x addresses hit 192.168.4.x addresses on my lan. I have added this command. Will this ...
Probably a dumb question. I have one policy map doing traffic shaping on an outgoing interface. I want to create another policy map for voip traffic and apply it to the same outgoing interface. Can I just use the service policy output command for ...
I will have the fiber patch tested. Using ethernet backbone speeds were fine and no input errors. On the fiber port, after changing where I was plugged in on the panel, the times were better, but the input errors were still increasing. Link light ...
Thanks again for all of your help. When applying this policy, should I apply to the subinterface for the voice vlan, or can I apply it to the main interface going out to the mpls cloud.
Here is the config. e0/1 connects to another router going offsite via dedicated circuit. That router has an address of 10.78.25.9, hence all the static routes pointing there. Remote sites recognize us as using the 10.234.8.x addresses. I want to ...
