Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there,We have recently aquired multiple Cisco AIR-AP4800-E-K9 and wanted to test them using the 9800-CL Virtual Wireless Controller.But we have been facing a problem on all of the devices, after the AP joins the controller, the WLAN is present ...
Hello there,we've recently been resetting some of our Cisco 2960-S series switches, and we are getting some weird post messages.When we boot into ROMMON and factory reset them, after the boot command when the firmware boots, we get 9 MBIST fails, but...
Hello there,we have recently acquired few used Cisco 2960-S series switches, and we are curious about something.While the switches are booting, we are getting a message after flashfs initialization.FIPS: Flash Key Check : BeginFIPS: Flash Key Check :...
Hi,we have managed to fix the problems by making a new VM to freshly configure the vWLC, and factory reset the Switch.On the switch, we setup power inline static max 30000 on the Gi1/0/48 on which the AP was connected.On the vWLC, we have just set up...
Hi,we have done the 2 of those things, and still the same problem occurs.But we dont understand the reply from @Stefan Mihajlov, didnt see a priority command when we did power inline on the interface, and mtu on the vWLC interface could only be chang...
Hi,we have enabled CDP/LLD on the switch port, the AP is stable until we try to access the network, as soon we try to connect to the Wi-Fi, we get connection failed and the AP gets this error.Switch#show cdp neighbors
Capability Codes: R - Router, T ...
Hi @balaji.bandi , thanks for the quick reply!the MBIST errors only occur when you go through ROMMON, and using "boot" command with or without the config.text.I have tried booting the switch without going through ROMMON with and without the config.te...
