Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have had several C3KX-PWR-714WAC V02 fail recently. All their serial #s started with DTN. Those starting with LIT seem to have no problems. Does anyone know about a series of manufacturing defects or something with these power supplies. While ...
I have a 4402 used as an Anchor for a WLAN used only for videoconferencing. These devices do not connect to our domain so they cannot use the normal WLANs. The problem we have appears to be jitter. There is a vendor server that these devices connect ...
We have recently replaced our 1242 APs with 1142s. I plan on using some of the 1242s on mobile carts. Does anyone know which would be the best 5.0Ghz antenna to use for this application? Looking at the dipole antennae on the web site did not give me ...
I needed a small wireless bridge to work with a Polycom V700 videoconference device we will be using for American Sign Language interpretation. It is not a Windows device. I thought about using a Cisco 1242 as a workgroup bridge but that is pretty ex...
I have a pair of PIX 525 set for failover. Since upgrading to 6.3(3), we have been having periodic failures in that the active device loses its running config, it transfers the default config to the standby. The proper config remains in flash and ...
We do have QoS throughout our network but we do not have it past the firewalls. We have videoconferencing and VOIP internally but this is the only thing that is anchored out the way it is. The WLAN has the highest level of QoS from the controllers. H...
I understand that it does not have a DHCP server. However, the V700 would not connect to a DHCP server even though it could ping it. It only worked with a static IP address. However, I will try again with the DHCP.
I have the same issue. In dense environments, it is normal to see this. It has caused some issues with older "B" devices getting very confused. I am looking into changing the algorithm to the 2.4 radio so it will power down lower than the defaults pr...
