Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need help to configure the access list on the outbound internet port to accept the following:ip access list 10access-list 10 permit PPTP vpn any xxx.xxx.xxx.xxxaccess-list 10 permit RDP any xxx.xxx.xxx.xxxaccess-list 10 permit FTP any xxx.xxx.xxx.x...
DHCP I have a cisco 2921 router connected to a cisco sg300-52 L3 switch. The switch is configured with several subnets and I need to use the router for DHCP. I setup DHCP on the router to assign addresses to a subnet on the switch but cannot get i...
I setup a new wireless system with a 2112 controller and 1142N AP. I get a dhcp address and connect to the wireless but no DNS and cannot see the WAN or my local network. I can ping the router.Need help.ThanksGJN
David,Thanks for the response. When I finally found where to download the sg300 maintenance manual I found where I needed to setup the switch as a DHCP relay for the various subnets on the switch. Thanks
