About soray

soray · 07-09-2008

I am trying to configure multicasting and I am having no luck. I have multicast enabled on the router and I also have IGMP enabled on the switch that it is connected to. I need multicast enabled for Paging to work on the network and I am having no lu...

soray · 08-06-2008

Have you tried resolving to the default WLC DNS name:DNS discovery-The access point can discover controllers through your domain name server (DNS). For the access point to do so, you must configure your DNS to return controller IP addresses in respon...

soray · 05-07-2008

Derly,Do you have WLC configured for Layer 3 LWAPP mode? This needs to be enabled if you are using light weights..I would check to see if this is option is set correctly.

soray · 05-07-2008

Hello Naidu - The highest IP address on the router will be the assigned router ID. With that being said. If the router have a loopback address assigned. Then the loopback address will be the router ID. If there are more than one loopback on the route...

soray · 05-06-2008

Hello Mahesh18 ~When they say CIR. They are talking about the committed rate that is guranteed. That means if any of your traffic exceeds that limit..it isn't guranteed. Thanks

Member Since	‎07-20-2007 08:41 AM
Date Last Visited	‎10-08-2024 03:50 AM
Posts	5
Total Helpful Votes Received	4

User Statistics

User Activity

multicasting

Re: WLC and AP on different subnets

Re: LWAPP problem

Re: question on DR

Re: CIR on MPLs link