Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a question related to the attached scratch. It's my intention to transport all VLANs (which are part of a dot1q-trunk) from the lefthand side to the righthand side and vice versa. The outer VLAN has only local relevance between the switch acce...
Hi colleagues, I have some strange problems to configure a multihome topology on the edge of a PBB-EVPN infrastructure.PBB-EVPN allows in contrast to VPLS and PW an all-active topology, which means all memberlinks of the MC-LAG distributed over multi...
ASR903 / RSP3 / IOS-XE 03.18.05.SP.156-2.SP5-ext Hi community members,I have a problem as follows. On a "normal" physical 10GE interface I have configured a parent egress policy which traffic-classes matchingon different service instances.I achieve a...
Hi, I have a problem in my small PBB-EVPN lab installation.Two PE routers (ASR9904) are directly connected via a 100GE link. On these two routers, a full and correct operating PBB-EVPN configuration is implemented.The ingress ports on the access side...
Hi,it is my intention to trust incoming COS values on the UNI Ingress of an ASR903 (RSP3, IOS 3.18.05.SP.156-2.SP5 ). On the UNI port, a service instance ethernet with an associated bridge domain is configured. DSCP is not analyzable in this setup.In...
I have tested this setup in CML and confirmed that "second-dot1q..." is mandatory to transport the VLAN trunk (including the outer VLAN). Transport without the outer VLAN seems to be impossible with this setup.
Hello Giuseppe,in the current configuration, all incoming VLAN-tags are popped off on ingress. Ingress-PE:#########################################################################Ingress-Port============interface TenGigE0/0/0/5cdpservice-policy inpu...
A little supplement to be more precise: The ingress policy receiving MPLS labeled packets indicates the correct labeled traffic in each class.The classification counters increases and the bandwidth usage in each class is correct, and the configured ...
I'm not sure if I have overlooked something....
But what is the right config to use more the two POA => Multi-homed device instead of dual-homed device?
With the singleton CLI command, it is no more necessary to configure the ICCP neighbor explicit.
...
