Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I didn't see this particular question when doing a search so I thought I would ask it here:The output of the show ip flow top-talkers command has SrcP and DstP in the header. Does this indicate source port and destination port, respectively? If ye...
Hi all,I have a c3550 and c7513 connected physically to each other and both are running ospf. One day their adjacency just died for about one minute and then went back up again. Below the logs for the c7513:%LINEPROTO-5-UPDOWN: Line protocol on Inter...
Hi All,I am currently running an old Cisco 7513 unit and just yesterday, we are having problems telnetting into it. Upon consoling into it, it appears all the vty lines are occupied from outside sources and did not time out.I tried doing a 'clear lin...
Hi everybody,I have two Cisco 7513s connected to our ISP via BGP. Router 1's IP is x.x.x.2Router 2's IP is x.x.x.3Our ISP's IP is x.x.x.1.Both routers are connected to the ISP IP.The weight on Router 1's BGP is set to 120 for while Router 2's is defa...
Hi All,I'm kinda new to BGP and still learning the kinks of the technology, hopefully you can help me with a little problem I'm having at the moment.Currently my connection is using BGP through a DS3 link that is running at 45 Mbps. I have a Metro-E ...
Hi all,Thank you for your replies. I'm trying to find the best time to actually do the recommended implementations and get back to you on my findings. Thanks again!
Hi,Thanks for replying. Actually, it was previously configured as below:line vty 0 4exec-timeout 3 0This should clear the line after 3 minutes idle time but some of the idle lines have been up for almost two weeks.This shouldn't happen unless it's so...
Hi All,Thanks for all the suggestions. The issue has been resolved. Apparently the problem was on the service provider end.Again, thank you for all the suggestions!
Hi Giuseppe,Thanks for the suggestion. Is there a reason why MED is preferred over weight in this scenario? Just trying to understand why this is important.Thanks!Muhammad
