Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,There was no Internet connection this morning and I looked at the router - the CD light was blinking fast.Router did not respond to SSH connection and I plugged in the console cable.sh run had factory default configuration. So I've restored the la...
Using CCP I am trying to create a NAT entry for a range of ports. CCP window for a new NAT has only one entry for the port #.Is it possible to set uf port ranges in 877 router?
Hi,This router was initially configured thru SDM software and later modified by CCP. They created the following ACLs:access-list 1 remark INSIDE_IF=Vlan1access-list 1 remark CCP_ACL Category=2access-list 1 permit anyaccess-list 2 remark Auto generate...
I am trying to set up Cacti to plot the ADSL values for investigation of systematic dropped carrier.What am I doing wrong?In IOS:#sh run | inc snmpaccess-list 11 permit 10.10.10.3access-list 100 permit udp 10.10.10.0 0.0.0.255 host 10.10.10.1 eq snmp...
Can anyone suggest what should be done to investigate why in the last 2 weeks there is an increase in dropped carrier from 1-2 a day to 20+ a day?Will enabling training log buffer provide any useful information?Should I attempt to use dsl noise-margi...
Is this a correct config? Please help!interface ATM0 no ip address shutdown!interface FastEthernet0 switchport access vlan 2 pppoe enable group global no cdp enable!interface FastEthernet1 switchport access vlan 2 pppoe enable group global no cdp ena...
