Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am having some issues with a new CME that I have configured in New Zealand. I can make local calls but can not call out International. I have checked with the telco and the ISDN Pri is not restricted. I'm assuming I have made a mess up with the...
Hi, Hope a voice guy can give me some advice on this. The company I work for supports various different sites that have their own CME. We would like to configure each CME so that if anyone were to dial the number 50000 it would dial our Servicedesk's...
HI, I am working on a ISM-SRE-300-K9 module that has previously been configured/managed by someone else. The module has 70 active mailbox licenses yet when I run the 'show licence detail' command (pasted below), there appears to be additional permane...
Hi,On an ASA is it possible to permit traffic from the domain name rather than the IP subnet? For example, say I wanted to permit all SMTP traffic from Cisco.com to a server on my DMZ. Can this be done and if so how?Thanks
Thanks for everyones help on this but after trying all suggestions, i am still have a issues dialing international. I am going to ring the Telco after the weekend and see if they can see any issues at their end. Below is my latest debug when calling...
I seem to be getting somewhere with this. I can dial internationally from the CLI line when I type the following command csim start 0061299512121but I still can't dial internationally from a handset. Must be something with my translation rules?
