Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I recently installed a couple of N540X-6Z18G-SYS-A for our customer, which are totally air-gapped. Their Smart Account is enabled for Specific License Reservation but the router doesn't seem to support most of the commands needed to register the ...
Hello,
I was looking some help to clarify I'm taking the right approach of a current customer DNA-C DR solution. I've been asked by a customer to look at their setup. At the moment it seems none of the units are talking to each other so both units ar...
Hello,
I'm trying to configure BFD parameters under BGP, and while it allows me to configure timers I can't seem to find how to configure BFD fall-over on my peer. It does allow me to configure BFD fast-detect but I specifically need to enable fall-o...
Hello,
I'm trying to register a few devices with CSSM directly. I have connectivity and the devices are configured but they all fail and display the generic message "Fail to send out Call Home HTTP message".
My firewall is permitting the traffic and...
TAC gave me some steps - some worked but other commands didn't take. For anyone in same boat for this model and software this is the command syntax I used to get it working:
Enable Licence Reservation on router
RP/0/RP0/CPU0# configureRP/0/RP0/CPU0(c...
I'm looking for the specific process and commands to use to configure offline SLR on this particular model and code. Unfortunately I cannot find this information anywhere so I've raised a TAC for assistance. I'll update if TAC identify a working proc...
Thanks for replying so quickly Sam! So if I apply BFD on the BGP global would that enable it for all peers or is there something I need to do to enable specifically for a neighbor (like enabling bfd fast-detect?)
