Hello all!
I am testing 8.3.112 and I am finding that clients are not reliably getting IPv6 addresses. On 8.2.130 clients reliably (as in always) get an IPv6 address (using SLAAC) and see the RAs from the router, however on 8.3.112 I am finding that ...
So I have 2 drops to each AP (2702's on the way). One will be data and the other console access. For lack of better terms, what termination order needs to be used for the console connection to a console server with RJ45 ports. Is it straight through,...
Here's the tough decision 2702 or 3702. Has anyone found any comparison between the two in terms of performance. 3 vs 4 transmit antennas make a huge difference. I don't see using the 3G module or security module in the 3702, but I do see the 3702 ha...
Hello,I just got an WAP371 yesterday. I am using the SB-PWR-INJ2 to power it over PoE. I updated the firmware to the latest version 1.0.1.5. I am experiencing terribly slow performance with the device. It is supposed to be replacing a N450 access poi...
I have read and read and read and from what I have read so far these switches are identical. They both support POE+, they both have 124 watts of POE power, they both have 8 POE ports, 10 gigabit ports. I for the life of me can't see what the differan...
So in reading the config guide for IPv6 clients in 8.x it is giving me the impression IPv6 needs to be enable on the network the APs are on as well? Is this true? The WLC has an IPv6 address on the management interface (as well as a v4 address) howev...
Most have DFS completely disabled. Although I was on a controller today that had it enabled and many APs were using DFS channels so I guess we have areas we have DFS enabled. I'm all for having DFS enabled and letting the AP change channel if it need...
No WMM. No WiFi handsets (well basically none. A few for testing purposes here and there, but no production deployments). Lots of softphone use on laptops, that performs just fine over WiFi and even over VPN from home which is way more latency and lo...
