Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have set up my branch and core routers to report Netflow data to our Orion server. They both send data, but the core router appears to report on all the data, while the branch router does not. Doing a "sh ip cache gi01 flow" at the core shows all...
Linked 5520 are getting HSRP messsages from their connected routers. I understand the messages are always there, but why are they showing up in the log and how can I either stop logging them or just ignore them?Jan 13 2009 08:40:24 firewallname : %AS...
I have been asked to build a test lab environment that looks like our production environment. I thought I would use policy and shaping commands on several VLANs in my 6500 to emulate T-1's and DS3's. Any suggestions? I realize I won't be able to get...
Currently, we are running this:Cisco 7206VXR (NPE300) processor (revision D) with 122880K/40960K bytes of memory.Processor board ID 18278379R7000 CPU at 262MHz, Implementation 39, Rev 1.0, 256KB L2 Cache6 slot VXR midplane, Version 2.1The question: w...
I have 3 PIX firewalls, 2 have almost constant communication with Ciscoworks. Every few minutes, CW thinks the firewall configuration has changed and goes out to get the new config. This happens around the clock. We can't figure out if the problem is...
Perhaps I should clarify.. I'm trying to do this with existing equipment in a very short timeframe. As far as I know, this is a "one shot deal" so no need to invest in serious simulation equipment.I'm looking for guidance on the policy and shaping co...
The Syslog analyzer was reporting "database error: failed to get message filters." I put a "bogus" filter out there and am now getting messages to come through. The debug never showed up.
