Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everybodyi have 12 fxo ports which connect to PSTN with my 2801 router and PVDM2-16and i have CUCM7.1 which is my Call Processing servermy problem is somtimes oitgoing calls through FXOs have problem, for example they have echo, delay and a maj...
Helloactually i have a problem with my CUCM7.1, i got the error on my CUCM Console " IpVms: StreamMixer: Excessive mixer calls (-100) "so teh -100 could be any number but all of them are minus, and after i got this error my outgoing or incomming call...
Dear allactually i'm looking for the IPS contract support for ASA5585 (SSP IPS), i found two type of this from internet with details below:CON-SNT-AS82S10K - SMARTNET 8X5XNBD ASA5580-20-10K-K9CON-SUO1-A8S2P2S9 - IPS SVC, ONSITE NBD ASA 5585-X w/SS...
hi everyoneactually i have a problem with my Cisco AS5300in my network, users call my AS5300 via E1 connection and aftre the call the dial some numbers (phone number ext.), actually its work fine for all telephone provider but only from one provider ...
dear allactually i used to connect my Internet via ADSL and i have to use this line as my telephone linei use splitter before i connect my line to ADSL modem, and i connect line to my FXO module on my 2801 routerafter i connect the line, i can not ca...
Dear Jonathan thank for your replayactually i'm already test this, but its not helptoday i'm thinking about the change the signaling from Loopstart to Ground Start, whats your opinion?? is it useful or no?
can you call form ATA?if its possible , dial the fax number which you want to send fax nad hear the fax tone, is it ok? and can you listen to handshake tone?
