Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello allI have a few SPA512G and SPA514G telephones (firmware version 7.6.2g - latest available) that use XML services for the phonebook, however once in a while when requesting the phonebook, the phone will hang on "Requesting" and the message [CMX...
Hi all
I have a spoke router (1921) in a dual hub DMVPN setup that keeps spewing this log message:
Oct 29 21:13:38 CDT: %NHRP-3-PAKREPLY: Receive Resolution Reply packet with error - insufficient resources(5)Oct 29 21:59:49 CDT: %NHRP-3-PAKREPLY: Re...
HelloI'm trying to set up a 3750-48PS-S switch with smartports. This is my (very simple config):macro auto execute GrpMAC remote tftp://192.168.0.1/glenn/smartport_intel.sh!macro auto mac-address-group GrpMAC oui list 000423!macro auto global process...
I'm experimenting with VRF's, I'm trying to do NAT from one VRF to another, using a loopback interface. I have one internet VRF (BLUE) and one "local" VRF (RED), and translation has to happen in the RED VRF. I've created a loopback interface which ha...
Hi allI'm trying to set up an 1801 router with two WAN interfaces, fastethernet0 and fastethernet1. On the LAN side, I have two subnets. One subnet's internet traffic should be routed over fastethernet0, the other over fastethernet1.I've setup some r...
The switch not returning back to its own internal powersupply is normal. You have to usepower rps 1 port 1 mode standbypower rps 1 port 1 mode activeto have the switch switch back to its own powersupply. You could use the EEM to make it revert to the...
Make sure you have the firmware for your phone ready with a correctly configured TFTP and DHCP server. Then:* When the phone boots, before the speaker light goes on, hold the # key, keep holding until you see the line lights sequence (this takes a wh...
With the help from above, looks like I messed up my NAT configuration but just not saw it. For completeness, the entire working configuration:Current configuration : 2532 bytes!! Last configuration change at 21:48:59 UTC Sun Dec 30 2012 by adminversi...
Which CPU bugs are you referring to exactly? Because I upgraded a 2960S last week to 15.0.2-SE and it wouldn't boot anymore (Unexpected exception to CPUvector 2000). I RMA'ed the unit, the new one had no problems with the iOS 15 firmware.
