Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,
We have some Cisco 9500 switches in our network running version 16.6.5 and I'm still getting the error message.
Not sure if anyone else is having the same problem. When you do the work around, something else times out. You work around ...
I have a Cisco 5520 HA pair and want to increase the license count so that additional AP's can register. I have an RTU license, please see the output below. I want to know how I can increase AP count to without "breaking" (reaching the limit of) t...
I have a HA WLC 5520 and we have ordered some new AP's (AIR-AP2802I-E-K9). They connect and register to the WLC however, they do not pass any traffic through the WLANs. Looking at the cisco help forums I can see that CSCvc67005 is the problem. Thi...
Hi Guys,
I’m having trouble configuring a Cisco ASA 5540 in transparent mode:
The current topology is below:
!
!
I would like only specified host/IP addresses to communicate with 192.168.0.101 and vice-versa, these devices are on the same...
Hi Everyone, I have a FQDN object on our Firewall, the IP address of this changes daily so the firewall has a rule to permit access to it on a specified port number. Example:access-list inside_access_in line 284 extended permit tcp host 192.168.0.25 ...
I had the issue too.I resolved it by deleting files that were no longer needed and rebooted it.Useful commands before and after the reboot are: show memory.You will delete files, but the used and free memory values remain the same.
Hi,
When you upgraded to 8.3.143.0, did you upgrade and reboot both the primary and standby? Also, did you make sure all of the AP's upgraded to software version 8.3.143.0?
Thank you
phipse
