About barnetth

barnetth · 04-06-2004

We are trying to get TAPS working on a CCM cluster. TAPS installed all services are running but when we call the CTI_RP we et a single ring and then the call disconnects.Extended Services is installed on the Publisher and the CTI_Ports are registerd ...

barnetth · 01-04-2002

I am not 100% sure but I think that your situation is correct. Have you had a look at your supervisor engine to see if the Layer 2 switch can see both devices via CDP. As CDP only runs at the data link layer this is the point I would expect to see bo...

barnetth · 01-04-2002

No. the Catalyst 3550 is a Layer 2 switch device and has no routing functionality

barnetth · 01-04-2002

It could be that the Network Modules installed in the 3640 are not supported on that perticular IOS version. Have you used the Hardware & Software Matrix tool ? Also check the amount of memory on the box.

Member Since	‎01-04-2002 05:51 AM
Date Last Visited	‎08-31-2018 12:01 AM
Posts	4

User Statistics

User Activity

TAPS not working on CCM 3.3(4) Extended Services 3.1(2)

Re: CDP not working between 7200 and Cat6k MSFC

Re: Catalyst 3550 routing

Re: IOS Upgrade problem