Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
3640 router with isdn bri card and mica(6 port),remote modem can not shakehand with mica,I turn on "debug modem trace all",display is below:00:16:02: Modem 2/1 Mica: configured for Answer mode, with Null signaling, 0x0 tone detection.00:16:02: Modem ...
a 6506 flex-wan module with atm pa-a3 oc3 interface,the other side is a FORE hub7000.they connected each other through a pvc.6506 configuration is:int atm 4/0/0ip address 172.18.254.17 255.255.255.252pvc 0/200protocol ip 172.18.254.18 broadcast I tur...
a 6506 flex-wan module with atm pa-a3 oc3 interface,the other side is a FORE hub7000.they connected each other through a pvc.6506 configuration is:int atm 4/0/0ip address 172.18.254.17 255.255.255.252pvc 0/200protocol ip 172.18.254.18 broadcast I tur...
a 6506 flex-wan module with atm pa-a3 oc3 interface,the other side is a FORE hub7000.they connected each other through a pvc.6506 configuration is:int atm 4/0/0ip address 172.18.254.17 255.255.255.252pvc 0/200protocol ip 172.18.254.18 broadcast I tur...
We have an ATM LANE network,now we get a 6506 with a PA-3A-oc3 in a Flexwan .As you know,this module does not support ATM LANE,it only support VC and 6506 must can communicate with ATM LANE . Do you have any suggestion?Thanks!
