Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,I am a starter to ISE. I have some thoughts, don't know if the deployment below works:1) ISE1 on SiteA, managing devices on SiteA 2) ISE2 on SiteB, managing devices on SiteB3) VPN Tunnle between SiteA and SiteB, ISE1 and ISE2 can communicate ...
Hello all,Could you please tell me why my Nexus 5672UP FC port only support 100m?while I found on Cisco technical specifications: So,1) why does my Nexus 5672UP only show 100m (OM3 fiber)2) as we all know, DS-SFP-FC32G-SW supports 16Gbps, if I want t...
Hi,
on a 2960xr (IOS Version 15.2(4)E7)
I run the following command,
Switch(config)# enable secret level 15 password cisco
but i failed to use password 'cisco' to login enable mode
what's wrong with this command?
thanks.
Dear all,I have created a channel group, all ports mode are "access", is it possible for me to change ALL PORTS to "trunk" without recreating the channel group?RegardsAlex
