Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We get hit with indirect link failures that we have to rely on Cacti to show. Sadly, it can take our NOC guys hours to detect. I'm thinking a TCL script that watches ifHCInOctets (.1.3.6.1.2.1.31.1.1.1.6) and ifHCOutOctets (1.3.6.1.2.1.31.1.1.1.10) a...
I'm trying to prevent people from creating vlans on our switches. The problem is I can restrict them to "switchport access vlan" but if they use a vlan that isn't on the switch it creates it automagically. Short of creating all my vlans and putting ...
When I poll a PIX for ifInDiscards and ifOutDiscards are these counters considered packet loss? The wording is a little vague:"The number of outbound packets which were chosen to be discarded even though no errors had been detected to prevent their ...
I have a 7600 with a sup 720 in slot 5.If I run cpmCPUTotal5minRev:CISCO-PROCESS-MIB::cpmCPUTotal5minRev.1 = Gauge32: 0 percentCISCO-PROCESS-MIB::cpmCPUTotal5minRev.2 = Gauge32: 4 percentCISCO-PROCESS-MIB::cpmCPUTotal5minRev.4 = Gauge32: 0 percentCI...
If I snmpwalk a 7600 with dual sups with cpmCPUTotal5minRev I get:CISCO-PROCESS-MIB::cpmCPUTotal5minRev.1 = Gauge32: 1 percentCISCO-PROCESS-MIB::cpmCPUTotal5minRev.2 = Gauge32: 2 percentCISCO-PROCESS-MIB::cpmCPUTotal5minRev.3 = Gauge32: 0 percent I'...
You have an issue there with your priority. You have standby 11 priority 115 on Router 1 while tracking interface G2/4. If you do not set an explicit decrement value, then the value is decreased by 10 for each interface that goes down, and dec...
"but that still doesn't stop it from running around WITHIN a VLAN" You are correct. The good thing is IPv6 devices use their MAC to go out looking for other IPv6 devices. You can capture the traffic with an IPS and use the MAC to find it. If you don'...
