Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone had any luck trying to launch a Tropo script from the UCCX rest editor step? I have been looking for a decent way to do post call survey with UCCX. I wish the products we deploy for collaboration integrated better. They seem to develop in ...
Has anyone had any luck trying to launch a Tropo script from the UCCX rest editor step? I have been looking for a decent way to do post call survey with UCCX. I wish the products we deploy for collaboration integrated better. They seem to develop in ...
I have a SPRAWLER set up for a test environment to test thing before we put them into production. I am to the point in the setup where I need to run UCCE License Administration. Does Cisco provide demo licenses for a lab setup? According to the doc C...
I have http and https running through an ipsec tunnel. http works fine but https does not. our servers always turn the don't frag bit on, we have Solaris running Iplanet and NT with IIS. I ran a trace and when the https packets reach 1453 bytes and t...
Under remote access VPN->Network Client Access->Group policies select the policy that is being used for your anyconnect profile and make sure under tunneling protocol you disable "Clientless SSL VPN" and enable SSL VPN Client, IPSEC v2 and L2TP/IPSEC...
In ASDM go to Configuration->Advanced->SSL Settings.... Make sure there is a third party signed certificate applied under the interface that is used for your VPN clients to connect to (your outside public interface). I recently changed ISP's and forg...
We use Solarwinds to monitor. This gives us the ability to set a custom bandwidth for an interface. Once the device is properly discovered you can edit the interface and set a custom bandwidth to 100Mbs.
When I used the msan certificate option for tomcat on the cucm publisher if the publisher imp node ever restarted Cisco sync agent would never start again. It appears to be an axl problem between imp and cucm. Tac was not able to resolve. As a workar...
I have the problem too version 11.5.1SU2. I am seeing this message in the service manager log:
ame="Cisco Sync Agent" Status="Stopped"><ReasonCode>-1019</ReasonCode>
Does someone know what 1019 is? I changed password to remove a , (comma) from the pa...
