Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am working with an undocumented customer Prime installation. Have got CLI access to the Primary and Secondary Prime appliance. Primary's NICs have physical problem. Need to promote the secondary to take over. HA is not configured.I have got ...
Hi,Currently facing a disk utilization issue on FMC1500 at a client. Clearing old updates, patches, and log files, recovered about 10GB but the /var partition is full again causing FMC GUI to stop working. Checking disk usage, the "sfsnort" director...
I am getting deny reverse path check errors when trying to host a TCP service on the firewall that has two ISP links.
Trying to host the service on ISP-2 IP range while the default route on the firewall is through ISP-1.
Using route-map to route the ...
Re: 5508 WLC Tx Power Control(TPC)- High Density Deployment
My Client's WLC is globally set to Fix AP power level to level 1. Is it possible to change this setting on an AP Group basis? Want to auto adjust power for a certain location. I...
I have SSH and SCP enabled on the ASA 5510. I can SSH fine into the device. However, I cannot copy files to the device usng WinSCP. Used all options but nothign seems to work. I see the log authentication successful, but then WinSCP reports no re...
Hi All,Just wanted to update for information.My issue is resolved. In the end I proceeded with clicking YES on the alert message and it replaced the expiring certificate, as intended. The message is correct, as the new certificate was intended to r...
Hi Rahul,Need clarification on your statement about obtaining the certificate from elsewhere. Does that apply to certificates obtained from a Microsoft Enterprise CA as well. I am trying to replace expiring certificates, used only for EAP Authentic...
Thanks Marce. Since there is no network connectivity on the primary appliance, I would have assumed the secondary to have taken over, without the need to shut down the primary, but it hasn't it seems. Maybe there is some sort of a problem on the se...
