Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Morning Techies! I am after some help. I have attempted to upgrade one of my clients S100v, and although all the logs indicate that the upgrade had been succesful, the Appliance failed to load the new verison.Fri Nov 8 11:03:28 2019 Info: Download an...
Hi Community, I came to work this morning to find one of my managed customers Ironport had crashed and the only recover was reboot as the console or GUI wasn't responding. At the time it happened, there would have been minimal users connecting throug...
Evening techies.... I am after a bit of advice... bare with me as I am firewall guy and only do UCS because of salesman....I have upgraded a clients c220m3 rack server using a firmware policy and the controller is reports as an unknown version and I ...
Looking for some help please.
I have a customer who is using C170 ESA and recently we had a mail with malicious content that usual is blocked, but got through.
Then I sent the mail myself from a test account with the same content and it was corre...
Hi everyone,
I have a customer who has seen an this issue;
A UDLD error condition has been detected please investigate.
10/10/2017 17:11 : PM-SW2_STBY-4-ERR_DISABLE 1418862: 10.60.10.60: Oct 10 16:11:33.895: %PM-SW2_STBY-4-ERR_DISABLE: bpduguard...
I think you have misunderstood the issue, smart license is not in use. The message is not indicating an issue with licenses, it is about an expired token
Thanks for the reply.Yes I have rebooted (this is part of the upgrade) I have done several of these in the past with no issues.When I say the version isn't on Cisco support, I know you don't see the download website on the CLI. What I mean about the ...
Hi, Thanks for your reply. I have tried that and I can see the FSM task complete. Is it worth downgrading and then attempting the task again? The controller asks for manual a/c power cycle. Which we do and that error clears but still reports the con...
